Tibetan and Himalayan Library - THL

THL Toolbox > Scanning & OCR > Scanning Books & Documents with Religious Studies Xerox Machine

Scanning Books and Documents with the Religious Studies Xerox Machine

Contributor(s): Steven Weinberger

To scan a book or documents with the Religious Studies Xerox machine:

1. Press the “e-mail” button on the screen
2. Press the “To” on the lefthand side of the screen and enter the email address to send the scan to
3. Press the “enter” button on the screen
4. Press the Options tab
5. Press “Build Job”
6. Press the “On” button
7. Press “save” button at the top of the screen
8. Press the “Advanced settings” tab
9. Press “Original input” button on the screen
10. Press “Manual Platen input” button on the screen
11. Set the size of book you are scanning
    1. If the book is exactly one of the sizes in the list, select that
    2. If the book is not exactly one of the sizes in the list, select Custom and then set the dimensions
12. Push the Save button at the top right of the screen
13. Begin scanning. Be sure to press the book down flat to get a good, clear scan. Scan each page by pressing the green plastic “Start” button at the lower right of top panel (to the right of the screen)
14. When you are done, press “build job controls” button at top of screen
15. Press “end build job” and the PDF will be sent to the email address you entered.
16. Notes: scan a few pages and check the image quality. If the scan quality is not clear, then adjust the settings. Try adjusting these settings until you get a good quality scan: Image quality tab > lighten/darken and/or Image quality tab > contrast/sharpness settings

Provided for unrestricted use by the Tibetan and Himalayan Library